Applies to: @RISK 6.x and Up

 

Changing the Tornado Graph in Quick Reports
By default, Quick Reports generate three graphs: histogram, cumulative S-curve, and change in output mean (tornado plot). To replace the tornado plot with correlation or regression sensitivities:

Versions 7.0 and later:

1. Before simulation, enable Simulation Settings » View » Automatically Generate Reports at End of Simulation.

2. After simulation, click the large Excel Reports icon in the ribbon.

3. Select Custom Reports from the list.

4. Go to the Custom Reports Settings tab.

5. Click Sensitivity Graph, then Edit, and select the desired type of sensitivity graph.

 

Earlier Versions:

1. In @RISK, go to Utilities » Application Settings » Sensitivity Defaults.

2. Change Preferred Calculation Method to one of the following:

   • Regression Coefficients

   • Regression Mapped Values

   • Correlation Coefficients

3. Click OK, then Yes to confirm.

4. Any Quick Reports generated afterward will use this new format for both the graph and the table to the right.

 

Limiting the Number of Tornado Bars
To limit the bars in tornado charts, go to Application Settings » Sensitivity Defaults and set Tornado Maximum # Bars to the desired number.

Related Article:

Tornado Graph — How to Set Defaults